Chief architect layout border templates1/12/2024 ![]() ![]() Though the arrangement and size of the title block is optional, the following information is considered mandatory: The title block is normally located in the lower right corner of the drawing sheet. A company that produces large castings, as an example, may have different notes than a company that makes small tools and dies. The form and information vary from company to company. The data may refer to company policy or to the drawing. They contain general as well as specific information. Title blocks are used to record all important information necessary for the working drawings. However, when drawings are stored in the electronic format, the wider border is not mandatory and can be 10 mm too. Traditionally, for the printed drawings the border is 20 mm wide on the binding edge and 10 mm wide on the other three sides, with resulting working area sizes as shown in Table 1. The Inside border encloses the working area, including the title block and other tables. The terms used in the table are clarified here: In Table 1 are shown the most widely used A and B Series of the ISO drawing sheet sizes, with A4 being the most popular size. First, we will consider the sheet sizes, drawing format, title blocks, and other parameters of the drawing form. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |